Engines for sale
ALL ENGINES CURRENTLY SOLD.
Please see below for rebuild spec and terms, conditions and warranty
Supplied with:
- 4 new engine mounts
- New control panel and extension loom (to enable panel mounting in the cabin)
- Driveplate for PRM 120 or 125, PRM 150, PRM 160 or 260
- Adapter plate for above
- Single 70amp alternator
- Exhaust outlet flange to 1 1/2" BSP male stub and gasket
- 6 month warranty
Refurbishment Info:
Cylinder Head
· Chemical clean
· Pressure test
· Valve guides inspected
· Valves inspected
· Stem seals replaced
· Valves reground
· Head skimmed
· New gasket
Block
· Strip (as far as required) and clean
· Crank inspected / polished (new seals and bearings)
· Big end bearings replaced
· Bores honed and measured – pass
· Piston rings replaced
· Sump plug washer replaced
· Sump gasket replaced
Fuel
· Injectors serviced / new nozzles
· Pumps cleaned and tested
· New injector seals / heat shields
· Rails cleaned (spill and fuel pumps)
· New rail seals
· Heater plugs replaced (if necessary)
· New fuel lines and clips (as required)
12v
All components tested, replaced/refurbed if required:
· Lift pump
· Stop solenoid
· Alternator(s)
· Starter motor
· Wiring loom removed, checked, repaired or replaced
Water System
· Pump removed, inspected
· New gasket
· New hoses and clips (as required)
· Header tank removed, inspected, tested
· New header cap and neck seal
External
· Repaint in blue engine enamel
· New mounts (except exchange engines)
· New custom made control panel (except exchange engines)
· Throttle / gear cable clamps replaced
· New alternator belt(s)
General
· Valve clearances checked / adjusted
· Operating test
· New oil
· New filters: oil/fuel/air